Shop New Arrivals
To place an order, call 855-715-1800
Your Shopping Cart
Shop by Category
Now that you have a curved shower rod, it’s important to install it correctly for safety and optimal usability. With just a few tools and easy steps, follow along to get your curved shower rod set up in no time.
Before installing, read the entire shower rod installation instructions. Observe all local building and safety codes.
Tools & Materials
Screwdriver
Hex Wrench
Screws
Mounting Brackets
Plug Anchors
Set Screws
Level
Drill
Hammer
Remove old rod and brackets from wall. Mounting brackets are 3" x 1-3/8".
Patch any existing holes from old hardware that will be exposed.
Measure distance between walls where shower curtain rod will mount. The rod can be cut down if needed. If so, use a hacksaw or tubing cutter to remove excess length, cutting the rod evenly on both sides. Rod ends will be covered by mounting brackets.
Use screwdriver to remove top and bottom screws from bracket. Separate bracket halves.
Place brackets on wall and mark holes with pencil.
Use 1/4" drill bit to drill hole for wall anchor.
Thread anchors into wall holes.
Use enclosed mounting screws and mount brackets halves on wall.
Place existing brackets halves on shower rod.
Place shower rod into brackets. Check for level and ensure that bow of rod is facing out from tub.
Tighten top and bottom screws to hold brackets halves together. Use hex wrench (included) to tighten rod set screws.
There are many benefits to curved shower rods over straight shower rods. Because they bow outward, curved shower rods fit many tub styles and create more space to maneuver within your shower. They also keep the wet shower curtain from clinging to you and help keep the water in the shower.
Since curved shower rods create more room in your shower, these work especially well in small bathrooms—at least if that includes a small shower. If the footprint of your bathroom is quite small, consider that a curved option will protrude into the space a bit.
While a traditional shower rod needs to be the precise distance between your shower walls and requires screws or other fasteners to stay in place, tension rods are installed using tension (via springs), allowing the user to adjust the length for the perfect fit.
While the ideal height of your shower rod depends on the length of your shower curtain, a good rule of thumb is to have your shower curtain hang about two inches from the floor to prevent mold or mildew from collecting.
When installing a curved shower rod, center it over your tub's edge for optimal use.