How to Install Feet to Cast Iron Clawfoot Tub

STEP 1

Carefully lay the tub upside down on towels (or other padding) on the floor so that the bottom of the tub faces up.

Slide a dovetail bolt into one of the mounting pods. (A mounting pod can be described as a raised piece on the bottom of the tub with a slot cut into one side.)

STEP 2

Match the tub foot with the corresponding pod.

Note: The feet must be installed correctly so the water drains from the tub properly. If the letters on your tub and feet do not match, use these guides to determine the mounting locations. The letters on your tub feet may differ from the guides.

STEP 3

Slide the foot down over the bolt. Thread a flat washer, locking washer, and nut onto the bolt (in that order). Be very careful not to overtighten the nut, this could strip the bolt.

STEP 4

After all feet are attached, flip the tub over and allow it to rest on the floor. Be sure to lift the tub by the rim only, never by the feet.

STEP 5

If the tub feet do not sit flush on the floor, plastic shims may need to be added to the feet. To adjust the tub feet with plastic shims, remove the foot and install a plastic shim between the foot and the foot bolt.

When the foot is aligned properly, secure it to the tub. Trim away any excess plastic.